Killer Tangle Free Cod Rig

Killer Tangle Free Cod Rig

I was never an advocate of "Bells and Whistles" When it came to rigs. Especially Cod.
I always used a 2 hook "High Low" rig tied on 60-80lb leader. The 6-10 in snelled 7/0 bait holders were looped through small dropper loops and that was it. If it was a sticky wreck one high hook did the trick. Often those rigs would get stuck and twist/tangle up. Here is a rig I have used with much sucess in New England New York an New Jersey.

Tip. Since there are not tons of Cod around I use the "Last one down is a rotten egg method". Meaning I am ready with bait on to hit the bottom as soon as possible after anchoring. When that Cod sees those grubs and clam on your hook first....you got him! "You snooze you lose"

The Cod are coming back. If you can't get out now, the Spring should be good too.

This rig works great when there is a current. It does not tangle and it catches Cod.

You can also remove the botom hook and replace it with a smaller hook on a snelled leader for ling.
DISCLAIMER...
CONDITIONS VARY SO NOTHING WORKS PERFECT ALL THE TIME AND I KNOW EVERY COD FISHERMAN HAS THERE FAVORITE RIG.

Materials

7 ft 80-100lb clear Leader
3 230lb Spro swivels
2 8/0 Mustad/Eagle Claw O'Shauhnessy
2 6-8 in Pink Grubs

First open eye of 8/0 hooks and attach swivel, close eye using pliers. The swivels allow the hooks and bait to rotate so the rig will not trist on itself.

Sharpen these hooks!!! I use a dremel to do this because it is fast. Whatever you use make sure the hooks are sharp.

1 Tie a Perfection loop in one end for the sinker
2 Tie a 6in dropper loop 6-8in up from the loop
3 Tie in another Dropper loop 3ft above the first.
4 Attach one Swivel with clinch Knot 6-10 in above last loop
5 Loop hooks on and thread on pink grubs.